![]() ![]() I would like my money back for all the Flex Seal products I bought and I don't think I should have to return the spray cans because it would be another annoyance for me to add on top of having to fix my bathroom floor. I have attempted to contact the Flex Seal company four times now and have received no response or acknowledgement. The product implied that it would be appropriate for floors and appropriate for indoors, however I do not think any product can be considered appropriate for indoor flooring if it cannot be cleaned even with the most natural cleaning products. I have asked the Flex Seal Company to reimburse me for the products, even though I think I deserve more as my bathroom floor is now going to take several hours to fix. Now I have to spend hours getting the entire coating off the bathroom floor as it has flaked off in several area and reapplying is useless if the floor cannot be cleaned with the product on it. Even the vinegar stripped the Flex Seal off the floor. I then went as natural as possible and just used plain vinegar on a new location. The Flex Seal was stripped once again by the cleaning product. I was shocked and tried to use a gentler cleaning product, I used **************** Clean Day All Purpose cleaner in a new area of the bathroom floor. ![]() The Flex Seal coating immediately started flaking off. A couple weeks later I went to wash my bathroom floor using a typical Vim floor cleaner. I left it to dry for two days before opening up the bathroom to use. I applied the liquid Flex Seal first and coated the entire bathroom floor. A couple weeks later I purchased two spray cans of Flex Seal liquid rubber from Canadian Tire for $19.99 each because I thought I would need more and I thought the can application would be easier then the liquid application. The product said it was able to be used indoors and able to be used on floors. ![]() KEEP OUT OF REACH OF CHILDREN.I purchased a can of Flex Seal Liquid for $29.94 CAD in order to give my bathroom floor a waterproof seal. Gloves and safety glasses are recommended. WARNING: Avoid contact with eyes and skin. Allow at least 48 hours for liquid to fully cure. When pouring Flex Seal Liquid into an area of depth greater than ¼ inch, allow each ¼ inch layer to cure completely before pouring the next layer. Pour Flex Seal Liquid directly on the surface, allowing gravity to take the liquid into cracks, holes, and/or other hard-to-reach areas.Continue to pour until the surface has been covered and all cracks and/or holes have been filled completely. Once fully cured, you will have a super strong, no slip, rubberized coating on the surface. Hang or clip object in the same vertical position as it came out of the can and let dry. Once you feel the surface has been fully coated, remove and let any excess liquid drip back into the can. Always brush or roll over a larger area than just where the leak occurred.ĭip object into Flex Seal Liquid, making a slight swirling motion. Apply several even coats until the surface has been completely covered and ALL cracks and holes have been filled. ![]() Flex Seal Liquid fully cures in 48 hours.īrush or roll Flex Seal Liquid using an even sweeping motion. Increase adhesion by etching surface with sand paper.Īllow each coat to dry completely (24 to 48 hours) before adding additional coats. You can either brush, roll, dip or pour Flex Seal Liquid directly onto surface. Protective clothing is recommended prior to starting any projects, make sure the surface is clean, dry and free of grease, oil and dirt. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |